Full 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the truck arrives.
Full-view glass
Chamberlain openers
Before
After
Before
After
Before
AfterGarage Door Before & After in Buford, GA
Most garage door companies tell you what they’ll do. We’d rather show you what we’ve already done. Since 2015, Servo Garage Doors Buford has completed 18,000+ jobs across Buford, Flowery Branch, Sugar Hill, and the Lake Lanier corridor. Every project below closed the same way: a written price agreed before work started, the failed part photographed, and a documented photo record delivered when the technician left. That’s Clause 1 and Clause 4 of The Haven Standard, and they’re non-negotiable.
Recent Transformations
Torsion Spring Replacement on a 16×7 Clopay Door in Buford
The problem: the left torsion spring measured 0.25-inch wire diameter and snapped mid-coil around 6:40 a.m. on a Tuesday, trapping an SUV inside. What we did: replaced both springs as a matched pair, not just the broken one, because the right spring had the same age and cycle count. The result: the door lifted smoothly on the first open, and the customer received photos of the break, the new springs, and the balance test before we pulled out of the driveway.
Garage Door Opener Logic Board Failure in a Wayne Dalton Setup
The problem: a LiftMaster opener mated to a Wayne Dalton door stopped responding to remotes and the wall console. The logic board showed visible scorch marks near the relay, which explained the intermittent behavior the homeowner had been living with for two weeks. What we did: replaced the board, reprogrammed travel limits, and tested the safety reverse circuit. The result: remotes and keypad restored, and the door now stops and reverses correctly on a 2×4 obstruction test.
Full Door Replacement: Rotted Bottom Section on an Amarr Door in Sugar Hill
The problem: the bottom panel had rotted where water pooled at the threshold for several winters. The steel skin separated from the stile, and the door sagged enough to drag on the track. What we did: replaced the bottom section with a color-matched Amarr panel, installed new weather seal, and re-set the track alignment. The result: the door clears the opening by a full half-inch now, and the homeowner has a photo record of the rot, the new panel, and the seal showing it was fixed, not just patched.
Emergency Cable Off-Track Repair on a Genie Door Near Lake Lanier
The problem: a cable snapped under tension while the door was opening, leaving the door jammed crooked and the homeowner unable to get her vehicle out. This is a high-tension cable situation, and we don’t recommend anyone attempt to release it themselves; a cable under residual spring load can fire off the drum with enough force to break bone. What we did: safely released residual tension, replaced both cables, reseated the door on its tracks, and rebalanced the spring. The result: the door cycles cleanly, and the photo record shows the snapped cable, the new pair, and the final alignment.
Track Realignment and Roller Replacement on a Craftsman Door in Flowery Branch
The problem: the vertical track had pulled away from the jamb after years of the door slamming against the header. The steel rollers had flat spots, so every open and close sounded like a shopping cart with a bad wheel. What we did: re-secured both tracks with longer lags into solid framing, replaced all ten rollers with nylon, and adjusted the opener’s down-force so the door stops without slamming. The result: the door runs quieter than it has in years, and the customer has before and after photos of the track gap and the new hardware.
Garage Door Opener Replacement: Chain to Belt Drive in Buford
The problem: the old chain drive opener had been loud since installation, but after 14 years, the chain had stretched so far that the trolley carriage slapped against the rail on every cycle. The homeowner’s bedroom sits directly above the garage, and she could hear every open. What we did: swapped the chain drive for a belt drive LiftMaster, replaced the rail, reprogrammed the remotes, and set the force limits to manufacturer spec. The result: she now asks Alexa to open the garage and can’t hear it from the bedroom, which is the whole point of a belt drive.
Want Results Like These?
Every job above started with a written price before any work began, and ended with a documented photo record of what was found and what was done. That’s how Servo Garage Doors Buford has operated since 2015, and that’s how your door gets treated. Call (470) 458-9647, and you’ll speak to a real person, not a recording. Bring a competing written estimate if you have one; we’ll give you a free second opinion on it.
Written by Marcus Deller, Owner at Servo Garage Doors Buford, serving Buford and the Lake Lanier area since 2015.